Landscape Plastic Edging Installation. To install landscape edging with brick, dig a trench where you want the edges to go and pack the bottom of the trench with scrap lumber so that it’s flat. Unravel the plastic edging and cut the amount you need to fit around your defined areas.

EasyFlex NoDig Plastic Landscape Edging Kit 40Ft Lawn
EasyFlex NoDig Plastic Landscape Edging Kit 40Ft Lawn from www.ebay.com

2) insert the edging into the scored section and hammer anchoring stakes (included) into the ground every 4 feet. Plastic edging along your borders and garden beds. It can be used in all climates and weather conditions, but it may deteriorate faster than steel or brick when exposed to direct sunlight for long periods.

Drive A Few Steel Stakes At A 45 Degree Angle Through The Lawn Edging Toward The Trench Wall To Hold The Edging In Place And Be Sure To Leave 2 Inches Undriven.

Installing the average plastic edging requires digging a trench for it first. Keeping any more visible on the top is not advisable because it may cause you or someone else to trip. To install landscape edging with brick, dig a trench where you want the edges to go and pack the bottom of the trench with scrap lumber so that it’s flat.

The Trench Should Be About 4 Inches Deep And As Wide As Your Edging Will Be, Usually 4 Or 5 Inches.

If installed correctly, the label should not be visible. Landscape edging is installed along the flower bed as a barrier so that the flower bed is not disturbed. Brick edging, paving stone edging.

Plastic Edging Along Your Borders And Garden Beds.

1) score the ground along your garden or flower bed. Lay down landscape fabric in the bottom of the trench, then fill it with soil. Specialty edging, low profile edging, paver edging.

2) Insert The Edging Into The Scored Section And Hammer Anchoring Stakes (Included) Into The Ground Every 4 Feet.

Step 1 unravel the coiled edging and place a source of weight to keep down both ends of the edging. Lightly water the area with a garden hose to settle the soil. Push it down into the trench until only ¼ to ½ inch is visible on the ground.

Brick Landscape Is Very Economical Since It Will Be Permanent When Used.

Unroll the circle so that the outside of the curl faces your flower bed. Unroll your plastic lawn edging and cut to the desired length. Installing metal landscape edging the finished edges on most metal edging products are rigid enough to let you install them with a mallet and 2×4.

By

Leave a Reply